TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

Another day in the Fab Shop
Read 1791 times
October 02, 2016, 07:11:06 PM
Some small print tests of my new Fabrication Shop Series.


October 02, 2016, 07:15:52 PM
A bit of work to do on 3d people before I go much further, not a lot of suitable characters out there and I also need a rigged character.


* October 03, 2016, 06:09:47 AM
That looks great. Stainless Steel pipe and fittings sure are expensive.
Have you checked 3D Warehouse for 3D people?

TC 21 Deluxe, TC 20 Platinum, TC 2015 Platinum, TC 2016 Platinum, TC 2017 Platinum
i7- 3770 Ivy Bridge 3.4 GHz, 16G Crucial Ballistic, ASRock Extreme 4, EVGA 1060 SSC, Windows 10 Pro 64 Bit

October 03, 2016, 06:23:36 AM
I have looked around Jason, the main problem in getting a high resolution model and I also need a rigged character that I can change the stance on.

I will probably look at poser or similar at some time in the future when funds allow.

If anyone has any links to good 3d people,please post them here!.


October 06, 2016, 12:43:38 AM
Very good, except I agree about the 3D person.


TC Pro Platinum 2020, 2019, 2018, 2017, 2016 & 2015 (all with LightWorks & RedSDK) & V21
System: i7-5820K @ 3.30GHz, ASRock X99 Extreme4, 16GB DDR4-2133 RAM, Gigabyte GTX 970, Samsung NVMe SSD 950 (256GB), Windows 7 Pro (64-bit) SP1