TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
The purpose of these forums is to discuss TurboCAD.  Please keep the discussion of other products to compatibility issues or how the other software’s can be used with TurboCAD.


No Magnetic Snap in TC Pro 2016
Read 775 times
* June 19, 2016, 01:39:25 PM
"Magnetic Snap" does not display in my TC Pro 2016.  This is obviously a repetitive historical problem since it appears as far back as 2010 on this forum.  Neither SEKE, Mode Snaps, or Snap Pallet cause the snap to display.  I have the most current and updated TCP 2016.  Any potential solutions would be appreciated.

Logged


June 20, 2016, 01:48:00 PM
#1
Assuming you have No Snap inactive in the Drawing Aids pop-up and Show Magnetic Point and Auxiliary lines active, it is almost always best to upload a file for independent confirmation (some bugs I have reported turn out to be something entirely different).


Jeff

Logged
TC Pro Platinum 2019, 2018, 2017, 2016 & 2015 (all with LightWorks & RedSDK) & V21
System: i7-5820K @ 3.30GHz, ASRock X99 Extreme4, 16GB DDR4-2133 RAM, Gigabyte GTX 970, Samsung NVMe SSD 950 (256GB), Windows 7 Pro (64-bit) SP1