It has been sometime between posting for me due to life's other things that she throws at us and it is about time I posted back.
I have been working on a PCB test fixture (bed of nails) which tests the integrity of a populated PCB. The fixture can also be used to program micros on the populated PCB. This simple mount plate is for a disposable interface PCB which has flying leads attached and when the leads go past their use-by, the complete PCB is replaced at minimal cost.
The drawing is very simple, but it shows I have been drawing (with TC 2015 PRO) and I shall later post an image of the PCB complete with stand off's on the mount plate.
For those that do not what I do, I work for and contract design for the electronics industry where I design and build robots, PCB test fixtures and various tooling for the industry. Some items I cannot show, but I can be selective and will dig some images out for you to view. Another post.
CREO 3 and 5
TC2018 Pro Platinum.
TurboCad V21 Pro Platinum 64 bit. TurboCad V21 Pro Platinum 32 bit CADCAM.
TurboCAD 2015 ProPlat.
TurboCAD LTE/DoubleCAD Pro V7.
TurboCAD Deluxe V21 64 bit.
VISI 21 CADCAM
Christchurch, Middle Earth.