TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Remember to do a search before you ask a question!!!

How to snap to center of a circle that has been exploded?
Read 1495 times
* May 05, 2015, 08:43:45 AM
I have a circle, that has been exploded.  Is there a way to snap to the center of the circle, that has been exploded? 

Logged
TuboCad Deluxe 2017. 
Newbie, but Getting There.


* May 05, 2015, 09:01:15 AM
#1
I have a circle, that has been exploded.  Is there a way to snap to the center of the circle, that has been exploded?

If it's only been exploded once it will be a polyline, select it,  Press and hold down the D key, place the cursor at the edge of the circle and press the E key (center of extents). That should do it. 

Logged
DonCW
2017 Pro with Light Works Plug in
2018 Platinum
2020 Platinum

Windows 10
There's so much to learn and not much time left to learn it.


* May 05, 2015, 09:24:07 AM
#2
And if you have explded it 2 time, you can make a rectangle from "qudrant1" to "quadrant 2" so you cover 1/4 of the circle and then snap to the "center" ( corner of the rectangle. )
Normally there will be vertexpoint on the place where the quadrantpoint was on the circle.

Torfinn

Logged
V20, V21, 2015/ 16/ 17/ 18/ 19 Pro. Platinum
Deluxe 2015/ 16/ 19
RedSDK enabled
Windows 10 Home Premium 64 bit, 32 GB
NVIDIA Geforce GTX 780m, 1 GB


* May 05, 2015, 09:26:51 AM
#3
it is a drawing that I imported into mine, from a vendor.  It was exploded into individual lines, when I got it.  So, i'll give the second a shot.  Thanks

Logged
TuboCad Deluxe 2017. 
Newbie, but Getting There.


* May 05, 2015, 09:28:44 AM
#4
it is a drawing that I imported into mine, from a vendor.  It was exploded into individual lines, when I got it.  So, i'll give the second a shot.  Thanks

If all else fails, replace the mess of lines with a Triple Point Circle.

Henry H

Logged