Question for a TC Pro 18:
Anal as it may be my objective is to show a rubber band mounted and realistically twisted up between two round posts much like youâ€™d have in a model airplaneâ€™s fuselage. The issue is the transition segment between each end and the helix at the center. Admittedly I simplified the part not including the bothersome bulging exterior as shown on the helix.
The rule for a loft has the guide lines as shown in a 2D plane, but I think this actually needs a 3 D plane here, looking at the end view as the material (yellow) leaves the helix abruptly and doesnâ€™t remotely comply - unless Iâ€™m not doing something right?