TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Remember to do a search before you ask a question!!!

Creating Springs in TurboCAD
Read 24586 times
* September 23, 2016, 12:30:02 PM
I have tried making the coil spring with short hooks.  I have gone through the steps and when it says to change the size z to zero that is grayed out and I can't change it.  I have been using turbocad for 2D drawings and now just started trying the 3D so I'm unsure if I have some setting incorrect.  Please help

Which section of the article are you working in?

Henry H


* December 14, 2018, 12:51:41 PM
I wasn't able to reply when you posted this, Henry. Thank you so much.