TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

Diamond Cut Cylinder
Read 1908 times
June 16, 2014, 08:16:26 PM
Here is something else I did just for the fun of it. It isn't anything - just a couple of shapes thrown together. I did, however, spend a good portion of time playing with materials and lighting. The diamond cut is a bump map. I hope t hat you like it.


June 17, 2014, 12:41:22 AM
#1
Excellent Don.
It looks as though it should be something useful.  :)

Regards Tim

Logged
Regards Tim

You can design without engineering, but you cannot engineer without design.
Using Win 10 with Designer 2017-2020 and TurboCAD Pro. Plat. 2018-2020 + Lightworks (64-bit versions) + AnimationLab 5.2.
Windows 10 Pro (1909) 64-bit


* June 17, 2014, 08:25:27 AM
#2
Finely done !!

Logged
Even a mistake may turn out to be the one thing necessary to a worthwhile achievement Henry Ford
If I have ever made any valuable discoveries it has been owing more to patient attention than to any other talent Isaac Newton
I have not failed Ive just found 10,000 ways that won't work Thomas Edison


June 17, 2014, 08:05:40 PM
#3
WOW! No wait, is that a photograph...?

Logged
SGEDESIGNS - - TurboCAD2020 Platinum - - WIN10-64 Dell Precision M7510 -- i7-6820HQ 2.7GHz -- 48Gb (!) RAM -- Quadro M2000M -- dual 24" 1920x1200 monitors -- UpBox+ 3D printer


* June 19, 2014, 05:32:25 AM
#4
Very nice Don, Thanks for sharing. Carroll

Logged
Carroll D. Peppersack
TurboCad 14.2 Deluxe
TurboCad 20 Plat