TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

ortho snap
Read 902 times
* March 25, 2014, 05:30:53 AM
A stupid question I know, but can't find the setting. I want my ortho snaps to snap in 45deg increments, mine will only go at 90deg. Just can't find it.

IV

Logged


* March 25, 2014, 05:40:04 AM
#1
A stupid question I know, but can't find the setting. I want my ortho snaps to snap in 45deg increments, mine will only go at 90deg. Just can't find it.

IV

Go to 'Options' Scroll down and open 'Angle' change Step angle value to 45. That should do it.

Logged


* March 25, 2014, 05:44:56 AM
#2
Don, You Are The Man, Dat DIDIT.

Hope things are going smooth up in BC.

IV

Logged


* March 25, 2014, 10:13:05 AM
#3
Don, You Are The Man, Dat DIDIT.

Hope things are going smooth up in BC.

IV

They're going good Ivey, hope about things in your part of the world?

Logged
DonCW
2017 Pro with Light Works Plug in
2018 Platinum

Windows 10
There's so much to learn and not much time left to learn it.