TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

Creating orthogonal views in a viewport
Read 2097 times
* October 21, 2009, 08:28:01 PM
I am in need of reviewing how to create orthogonal views in a viewport.  I recall that SoftDev SPb produced a short and helpful tutorial that illustrated this process.  I believe that the tutorial was made for TC version 10.  A link to the SoftDev tutorial was listed in the old forum.  Can a link to this SoftDev tutorial be made available again.  Thank you.

Mark Gorton