TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

warning message after testing 3d then drawing in 2d
Read 876 times
* November 16, 2012, 03:24:37 PM

i'm taking the two turbocad training courses (2d and 3d) and i'm just at the end of the 2d course. there was an example we were to load to get an understanding of the xreference which used a 3d model. now i'm back at the drawing that was used through sessions 10, 11 and 12 which is 2d only. when i select an object i now get a warning as follows:

"selecting the object in the 2d mode changes the drawing's workplane. do you want to contnue?"

i'm sure that when i get into the 3d course it will be explained, but wanted to know what this is referencing. there is an option to not display the message again, but i'm curious as to how this happened and if there is a way to correct the condition i've encountered.

thanks in advance!!



* November 16, 2012, 04:07:57 PM
Nothing to care about, TC only telling you that you switching from 2d > 3d mode, very anoying, so good its possible to turn of :)


V20, V21, 2015/ 16/ 17/ 18/ 19 Pro. Platinum
Deluxe 2015/ 16/ 19
RedSDK enabled
Windows 10 Home Premium 64 bit, 32 GB
NVIDIA Geforce GTX 780m, 1 GB

* November 16, 2012, 04:20:44 PM
hi torfinn:

thanks very much.