TurboCAD Forums

Turbo Talk => General Discussion => Topic started by: Tim Stewart on August 04, 2009, 07:41:56 AM

Title: IMSI on R'n'R?
Post by: Tim Stewart on August 04, 2009, 07:41:56 AM

Just a quick question, as I am still waiting on replies to email concerning Animation Lab.

Is everyone at IMSI on holiday, sick, too busy working, . . . . on the next updates?

I just wondered.

Thank you all, in anticipation.

Regards Tim
Title: Re: IMSI on R'n'R?
Post by: wd on August 04, 2009, 08:18:46 AM
"Is everyone at IMSI on holiday, sick, too busy working,"


They may be at the country club punting around golf balls and sipping apple martinis in the refreshment taberna.Or driving there Beamers with the top down letting there hair blow briskly in the wind. Just little pun intended.

W.D. :)
Title: Re: IMSI on R'n'R?
Post by: turbotech on August 04, 2009, 08:50:24 AM
I believe I have sent the link to you three or four times now.  It may be getting blocked.  I will send it again with the link not active.
Title: many thn
Post by: Tim Stewart on August 04, 2009, 11:26:33 AM
I believe I have sent the link to you three or four times now.  It may be getting blocked.  I will send it again with the link not active.

Hi Rip,

many thanks.  Sorry to have bothered you again.

I downloaded again, via your email today.

Removed earlier version of AnimationLab v4.  Rebooted computer.  Installed latest version.  Installation then asked for serial number, which, as I mentioned previously, I do not have.  I have looked again through the many programme serial numbers and licences I have listed in Code Numbers File(of course!), and cannot locate anything for AnimationLab.

Could I ask if you have a copy from my original purchase, or, could you please generate a new one?

My apologies for being such a pain!

Regards Tim


Title: Re: IMSI on R'n'R?
Post by: turbotech on August 07, 2009, 03:00:13 PM
Check your e-mail
Title: Re: IMSI on R'n'R?
Post by: Tim Stewart on August 08, 2009, 10:37:38 AM
Check your e-mail

Many thanks Rip.  Put contents into a safe place!

It'll be nice to transfer everything over to v16, at last.


Regards Tim