TurboCAD Forums

Turbo Talk => FAQs => Topic started by: Ehtisham Mehmood IMSI on December 10, 2018, 08:37:27 AM

Title: Center mark disappears when the drawing is saved in PDF (PRC) file format
Post by: Ehtisham Mehmood IMSI on December 10, 2018, 08:37:27 AM
Issue:
Center mark disappears when the drawing is saved in PRC based PDF file format

Reason:
The PRC-based PDF format does not support 2D entities. Any entity which is 2D, will be eliminated when saving as PRC PDF format. This is the default behavior of this file format. The PRC-based PDF format does not support 2D entities.