TurboCAD Forums

Turbo Talk => General Discussion => Topic started by: DonCW on November 08, 2014, 06:16:01 AM

Title: TC Warning
Post by: DonCW on November 08, 2014, 06:16:01 AM
I'm starting to use Render in v20 Pro and I'm the attached warning message. Is it something to be concerned with?
Title: Re: TC Warning
Post by: John R on November 08, 2014, 06:54:45 AM
re: …Is it something to be concerned with?

I don't think so if running 64-bit, but you can turn those settings off, if it becomes necessary.

Having any Foreground Wireframe are on (Nonrenderable objects, etc. in Camera Properties)
when OpenGL Hardware Acceleration is enabled
may cause significantly lower performance.
Title: Re: TC Warning
Post by: TravisFleenor on November 18, 2014, 01:16:30 PM
Don,

If you notice any slowness or compromised performance of any kind while drawing in wire frame you can turn off openGL Acceleration using the check box highlighted and circled in red on the attached screenshot (Options-->Program Setup-->Desktop). Otherwise this is just a warning dialog and nothing to worry about :).