TurboCAD Forums

Turbo Talk => General Discussion => Topic started by: qfci on April 11, 2014, 08:49:28 AM

Title: sweep to solid
Post by: qfci on April 11, 2014, 08:49:28 AM
I need to change a sweep to a solid, then 3d add it to another solid,

I did it once, now I can't figure out again.

IV
Title: Re: sweep to solid
Post by: Bud Lovel on April 11, 2014, 09:01:42 AM
explode your sweep once and then add it to your other solid
Title: Re: sweep to solid
Post by: qfci on April 11, 2014, 09:08:49 AM
Thanks, I'll try that,
Title: Re: sweep to solid
Post by: qfci on April 11, 2014, 09:11:21 AM
BOOM, that was it, step, steps, steps, it's all in the steps,

Thanks Bud
Title: Re: sweep to solid
Post by: DonCW on April 11, 2014, 04:59:23 PM
BOOM, that was it, step, steps, steps, it's all in the steps,

Thanks Bud

That also applies to Simple extrude. Explode 1 time to change ACIS Solid.