TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When posting a problem be sure to include which version you are using.  Give as much information as possible.  If the problem is with a specific file be sure to attache it to your post.

Problem selecting text for milling in TC14.2
Read 1574 times
* September 06, 2012, 10:37:29 AM
Hi there, I have encountered another problem when trying to select text for milling it is similar to a problem I had previously where when I try to select text for milling "define new position for relative/polar origin" appeared and this was resolved with help from fellow forum users by toggling between absolute and reletive coordinates, but this time the promt in the lower left screen says "click text" and a box with a red cross appears saying, "cant perform operation. Please check parameters in the inspection bar". Can anyone please help.

Logged


September 11, 2012, 07:11:30 AM
#1
That is a new one on me. Try selecting "Workplane By Active View" then set relative origin & see if that helps.

Logged
TurboCAD user since v3
 TurboCAD on flickr || My twitter ||