TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
All posts discussing pricing or where to buy TurboCAD will be deleted.

14 Pro symbol question
Read 1268 times
* July 26, 2012, 02:50:14 PM
So...I don't use my TCW 14 pro software very often at all, but I'm hiking up the learning curve here.

I am doing a floor plan for our home renovation, and I'm trying to insert a toilet symbol from my symbol library.  I had no trouble inserting it into layer 0 using "drag and drop," but if I try to insert it into the layer for the second floor, it gives me an error message: "Object extents are invalid. Object(s) will be deselected!"...and then drops the toilet symbol back on level 0.  I have made sure I'm working on the layer I want the symbol to land on, and that the correct ones are visible and all...but this is driving me NUTS! Any suggestions?

Logged


* July 26, 2012, 09:31:46 PM
#1
I believe this was answered in the topic: Symbols will only drop into layer 0...any help, that you posted a few minutes after this.

Logged
John R.

V17—V21, 2015—2019
Designer, Deluxe, (Professional, Expert, Basic), Platinum
RedSDK enabled
Windows 10 Pro (1803), 64-bit