TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When replying to a specific statement be sure to quote the previous post.

Viewports and Scaling
Read 1545 times
* September 15, 2009, 12:26:21 AM
As a complete beginner could somebody please guide me as to how I obtain a scaled view on paper space.
At the moment what I do is;
1 - Create a view in model space
2 - Go to paper space and insert a viewport
3 - Size the viewport as required by drawing the marquee
4 - Insert the named veiw.
However what this is doing is putting the named view in to the viewport, which bears no relation to scale.
I would like to do a paper space view od say 1:100

Thanks
Mgraw

Logged


* September 15, 2009, 01:24:38 AM
#1
re: Viewport Scale

Select the Viewport
go to Properties — Viewport page
In the Scale section, checkmark "Fixed"
In the Scale field, if "1:100" isn't available, type it in over the current value.
OK back to the drawing

the end :)

Logged
John R.

V17—V21, 2015—2018
Designer, Deluxe, Expert, Basic, Platinum
RedSDK enabled, except in 2018
Windows 10, 64-bit


* September 15, 2009, 03:26:34 AM
#2
John R, many thanks for your advice, which of course worked a treat.

Thanks again.

Mgraw

Logged