TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When replying to a specific statement be sure to quote the previous post.

Dimension
Read 1394 times
* September 14, 2009, 08:02:30 AM
     What is the correct way to get the dimension in a drawing?
If I have a square and look for “H” and   â€œW”
1)   do I use the  “SEKE” keys I or V and then pick a line, or
2)    You use the snap version “S’?
If I use 1) I will get a different dim. then when I use 2)
.090” the correct dimension with ‘I’ or ‘V’
.100” With the “S” version.
   thanks
Hilmar

Logged


* September 14, 2009, 08:56:34 AM
#1
I generally "V" snap to each end of the line I wish to dimension. Another method is to enable Segment Dimensioning, in which case it is necessary only to select the line to be dimensioned.

Henry H

Logged