TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When posting a problem be sure to include which version you are using.  Give as much information as possible.  If the problem is with a specific file be sure to attache it to your post.

Constraints with Splines
Read 1500 times
* September 08, 2009, 10:09:37 AM
It is possible to connect a spline to two lines using the CONNECT constraint without moving or resizing the lines?  (See attached).

When I use the anchor constraint on the lines I get all kinds of bizarre behavior. For example, getting the spline connected to the line but not at the end.

[attachment deleted by admin]

Logged


September 08, 2009, 10:21:40 AM
#1
You go first to the spline and selct there the points, and then to the lines.

Logged