TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When posting a problem be sure to include which version you are using.  Give as much information as possible.  If the problem is with a specific file be sure to attache it to your post.

FM10 and TC19
Read 2595 times
* March 31, 2012, 07:48:13 AM
What's the situation with TC19 64 Bit and Furniture Maker 10? Will they work together? Should I re-install? Am I limited to 32Bit TC19?

We want to know!

What is happening?

Milan: Where are you -- I'm back at my desk and waiting for the upgrade. Are you working hard?

Logged
WillR
SW:TC 21 Pro Platinum, FM15, 20 Pro Platinum 64 Bit, also V 19.1 64Bit & 32 bit 17.2 and 18.1; Furniture Maker 14 and 10. HW: Vista 64 Ultimate, AMD 1090 (6 core) 8GB memory Plus also an AMD  8 core systemFX


* September 20, 2012, 03:39:34 PM
#1
Wow - no reply to this yet? I am running the trial of 19.
Looks like I better stay at 18 with FM 10 working.
Too many issues I see already pay another $200.

Logged


* September 28, 2012, 04:05:50 PM
#2
The 10.1 is on Special at $99.

But Milan never replied to my email asking about bugs.

Even the label formats they did only work with their pre-entered materials. When I use them for my materials I get a fault.

Oh well -- back to the drawing board.

No upgrade price. Maybe there should be an upgrade price -- like it never did work properly eh?

Logged
WillR
SW:TC 21 Pro Platinum, FM15, 20 Pro Platinum 64 Bit, also V 19.1 64Bit & 32 bit 17.2 and 18.1; Furniture Maker 14 and 10. HW: Vista 64 Ultimate, AMD 1090 (6 core) 8GB memory Plus also an AMD  8 core systemFX