TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

Drill
Read 2914 times
* August 14, 2009, 03:13:59 AM
Hi All!

It's my first model in TurboCAD. TC is very pretty program to make drawings like this too fast.

[attachment deleted by admin]

Logged


* August 14, 2009, 04:02:55 AM
#1
Or another two versions with various size and count of nuances...



[attachment deleted by admin]
« Last Edit: August 14, 2009, 04:23:55 AM by TCNov »

Logged


* August 14, 2009, 10:38:06 AM
#2
Very nice job. Looks like a fun project.

Henry H

Logged


* August 14, 2009, 03:02:02 PM
#3
Very nice for a first model. The little knobs on the handle could have been better; maybe just a quarter of the sphere showing outside the handle.

Logged
John R.

V17—V21, 2015—2018
Designer, Deluxe, Expert, Basic, Platinum
RedSDK enabled, except in 2018
Windows 10, 64-bit


* August 15, 2009, 02:55:12 AM
#4
Congratulations.
The modelling is very good, but I have 2 very minor criticisms of the actual model itself...

1. The chuck jaws are too round, the 'insides' should be almost V shaped so they can close enough to hold small drills.
2. You omitted the holes (usually 3 at 120 degrees apart) for the chuck key. There is a hint of a hole that would suggest you have two at 180 degrees apart, but I've never seen a chuck like that.

They don't detract from the actual modelling though.

Logged
Gary Wooding
Win10 64-bit,
TC21.2 x64 Plat, Bld59
TC16.2 Plat, Bld54.0
TCC 3.5


* August 15, 2009, 05:41:56 AM
#5
The handle with knurl would give it a nice appearance. :) It still nice project.

Logged
Even a mistake may turn out to be the one thing necessary to a worthwhile achievement Henry Ford
If I have ever made any valuable discoveries it has been owing more to patient attention than to any other talent Isaac Newton
I have not failed Ive just found 10,000 ways that won't work Thomas Edison