When I use imprint to create a mitre (imprint (block on 45), select substract) and then copy the part only the base part is copied. The profile goes with the part but not the subtract. Should this work or is there a better way. Some times I get an error message as mentioned my previous post.
The imprint is in the selection info for the copied part but it is red, for the first part it is green.
Slice can be used to do the same thing and I don't get an error in the selection info.
See second image.
[attachment deleted by admin]
« Last Edit: August 13, 2009, 08:56:38 AM by marchmoran »
TC Ver. 21.2 Build 59.0
Win 7 64 bit Dell i7 2.70Gz 16 GB