TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

cannot make an angular construction line
Read 757 times
* January 15, 2012, 05:43:38 AM
I am using turbocad pro 14.2 and for some reason now it wont let me make an agular construction.  It seems as though it is on a different workplane but only makes a vertical or horizontal line.  I am stumped havent changed any settings.  any suggestions?

Logged


* January 15, 2012, 09:01:48 AM
#1
I can't really say for sure, but are you clicking on angular construction line?

Logged
Carroll D. Peppersack
TurboCad 14.2 Deluxe
TurboCad 20 Plat


* January 15, 2012, 10:23:16 AM
#2
I am using turbocad pro 14.2 and for some reason now it wont let me make an agular construction.  It seems as though it is on a different workplane but only makes a vertical or horizontal line.  I am stumped havent changed any settings.  any suggestions?

It sounds like Ortho Mode might be active, right click on SNAP at the bottom of the screen to open Drawing Aids. If the box to the left of Ortho Mode has a check in it left click on it to clear. Angular Construction lines should be available now.
« Last Edit: January 15, 2012, 10:42:58 AM by Don W, »

Logged
DonCW

2017 Platinum
Light Works Plug in
Windows 10
There's so much to learn and not much time left to learn it.