TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When replying to a specific statement be sure to quote the previous post.

Request help with changing material to a 3D part
Read 1493 times
* August 08, 2009, 09:12:52 PM
I am having problems with changing the material to all of a 3D part in one go. 

All my attempts have only allowed me to change one section at a time.  ???

Please find below a 3D part I am working on.  Shown is that only one hole changed to the new material.

Any assistance will be greatly appreciated.

I am using TCPro Ver 16

Thank you,

Keith



[attachment deleted by admin]
« Last Edit: August 08, 2009, 09:17:00 PM by Keith2009 »

Logged


* August 09, 2009, 08:22:45 AM
#1
How to do it:

Open the Materials palette. Activate Facet editing; select any facet of the part; press Ctrl+A, which selects all its facets. Right click in the Materials palette and choose "Set 'None'." Click in the drawing area to deselect the object's facets; press the Spacebar to exit the facet editor; then double-click on the object to open its Properties dialog. Click "3D" in the left side of the Properties dialog to access the object's material; open the Material list and select "None" (Category doesn't matter).

Now you can set new material/materials for the object using either its Properties dialog or the Materials palette or both.

Henry H

Logged


* August 10, 2009, 02:10:16 AM
#2
Henry,

Thank you very much, that worked a treat  :)

Kindest regards,

Keith
Perth,  Australia

Logged


* August 10, 2009, 10:03:56 AM
#3
Thank you very much, that worked a treat  :)

You're welcome!

Henry H

Logged