TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When replying to a specific statement be sure to quote the previous post.

Toolbars move to the right
Read 1854 times
* August 08, 2009, 08:22:01 AM
My Turbocad tool bars move to the right each time I start Turbocad.  I have to grab them and move them to the left or, after several starts and restarts, they start disappearing on the right side of Turbocad.

I believe this was addressed in the old forum; however, I get an error whenever I try to load the old forum.  Apparently the old forum is dead. 

I am currently using TCad 10.5.

Any help would be appreciated.

Logged


* August 08, 2009, 09:13:54 AM
#1
From time to time it happens on my 11.2 Pro system too.
I never did figure out why it happens. Sorry.

Logged
Gary Wooding
Win10 64-bit,
TC21.2 x64 Plat, Bld59
TC16.2 Plat, Bld54.0
TCC 3.5


* August 08, 2009, 10:46:05 AM
#2
re: My TurboCAD toolbars move to the right each time I start TurboCAD.

Toolbars or Palettes?

When palettes were docked in a second monitor, they used to slowly creep up and to the left 1 pixel every time the program was started.
If toolbars, are these floating (undocked)?

The only thing I can think to do, is to create a custom configuration and load it when everything gets too far out of sync. That what I had to do to get my palette nest back into place.

The New UI that began in Version 12, cured some of the "creep" problems.
« Last Edit: August 08, 2009, 10:49:01 AM by John R »

Logged
John R.

V17—V21, 2015—2019
Designer, Deluxe, (Professional, Expert, Basic), Platinum
RedSDK enabled
Windows 10 Pro (1803), 64-bit


* August 08, 2009, 07:49:16 PM
#3
The toolbars move.

I never bothered to install V12 as it did not include VBA.  I have no interest in using VB script.

Logged


* August 08, 2009, 08:09:12 PM
#4
The toolbars move.

I never bothered to install V12 as it did not include VBA.  I have no interest in using VB script.

I've heard it isn't legal (don't know if that's true), but it is physically possible to copy VbaTool.dll from an earlier version's Draggers folder into v12's Draggers. I've also heard that it really works ;-)

Henry H

Logged