TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
The purpose of these forums is to discuss TurboCAD.  Please keep the discussion of other products to compatibility issues or how the other software’s can be used with TurboCAD.


Small ally powder flow regulators for a food plant
Read 3835 times
October 27, 2011, 11:58:51 PM
These were made with TCC and a machining centre from 5000 series Ally the stock as you can see in the other pic is a piece of 38x25x2mm RHS

Logged
Gee dad.......... what could go wrong ( see Pic)


October 28, 2011, 12:03:15 AM
#1
the stock material

Logged
Gee dad.......... what could go wrong ( see Pic)


October 28, 2011, 03:44:45 AM
#2
Nice Job. Small parts are always the hardest to make.

Logged
TurboCAD user since v3
 TurboCAD on flickr || My twitter ||


October 28, 2011, 08:48:00 PM
#3
Thanks
 I expected a few to get caught in the cutter and get crunched but the only problem was finding them after the coolant washed them away. RHS made it easer too A ridged set up and the components somewhere to go clear of the cutter

You seam to be a little of a lone voice in TCC land
This is my first forum I have joined I have read a lot of the postings and will try to avoid newbei mistakes
thanks for the feed back
shame about the time difference

Logged
Gee dad.......... what could go wrong ( see Pic)