TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
The purpose of these forums is to discuss TurboCAD.  Please keep the discussion of other products to compatibility issues or how the other software’s can be used with TurboCAD.


Part holding jig
Read 3358 times
September 30, 2011, 04:18:11 PM
A jig used to hold thin plastic, circuit boards and large blocks. Pictured is my smallest mill it is a Maxnc cnc mill controlled by Mach3.

Logged
Engineering 30 plus years


September 30, 2011, 04:20:12 PM
#1
A few more pictures.

Logged
Engineering 30 plus years


September 30, 2011, 04:20:50 PM
#2
A few more pictures.

Logged
Engineering 30 plus years


September 30, 2011, 04:21:24 PM
#3
A few more pictures.

Logged
Engineering 30 plus years


September 30, 2011, 04:21:41 PM
#4
A few more pictures.

Logged
Engineering 30 plus years


September 30, 2011, 04:22:14 PM
#5
A few more pictures.

Logged
Engineering 30 plus years


September 30, 2011, 04:22:50 PM
#6
A few more pictures.

Logged
Engineering 30 plus years


October 01, 2011, 07:19:37 PM
#7
When milling larger parts out of plastic I clamp MFD board to the mill.

Logged
Engineering 30 plus years


October 01, 2011, 07:20:39 PM
#8
Then screw the plastic to the MDF spoil board.

Logged
Engineering 30 plus years


October 03, 2011, 07:29:32 AM
#9
Nice bit of fixturing, Gletha. Did you do the CNC conversions on your machines or were they bought as CNC?

Logged
TurboCAD user since v3
 TurboCAD on flickr || My twitter ||


October 03, 2011, 04:08:43 PM
#10
They were bought CNC.

Logged
Engineering 30 plus years