TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When posting a problem be sure to include which version you are using.  Give as much information as possible.  If the problem is with a specific file be sure to attache it to your post.

vertical text
Read 2001 times
* June 21, 2011, 12:57:47 PM
Sorry if this is a repeat or a "sticky" somewhere, but how do I go about creating or manipulating text into a vertical position?  TC Deluxe 17.0

Logged


* June 21, 2011, 01:06:36 PM
#1
Via the inspector bar in the Rotation x,y,z in 3d Mode

Logged
Even a mistake may turn out to be the one thing necessary to a worthwhile achievement Henry Ford
If I have ever made any valuable discoveries it has been owing more to patient attention than to any other talent Isaac Newton
I have not failed Ive just found 10,000 ways that won't work Thomas Edison


* June 21, 2011, 01:16:14 PM
#2
Is this possible in 2D? 

Logged


June 21, 2011, 01:17:13 PM
#3
If you mean vertical orientation of letters (like MSWord WordArt) that can't be done in TC. You could hit "enter" after each letter to stack them.

Logged
Julian

TC18 / 38.5 Platinum, AL5. XP, Core2 Duo E6750 OC'd 3.0Ghz, Render test: 3mins 3sec.


* June 21, 2011, 01:20:22 PM
#4
Yes.Also can perform different changes in the Selection Info Palette to the text.Also rotating the text by selecting the handles

Logged
Even a mistake may turn out to be the one thing necessary to a worthwhile achievement Henry Ford
If I have ever made any valuable discoveries it has been owing more to patient attention than to any other talent Isaac Newton
I have not failed Ive just found 10,000 ways that won't work Thomas Edison


* June 21, 2011, 01:25:45 PM
#5
Julian - that is exactly what I meant.  Thank you for the info.

Logged