TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
The purpose of these forums is to discuss TurboCAD.  Please keep the discussion of other products to compatibility issues or how the other software’s can be used with TurboCAD.


10 Area of Inertia to Moment of Inertia, & 2) Printing from rolls.
Read 3607 times
* March 23, 2011, 07:18:47 AM
1)  For a solid, I believe TC shows a volume of inertia (e.g. vol *X^2) which units would be X^5, not the X^4 shown.  I think it should be modified to show wether it is an area of inertia (for a membrane, units X^4), or a volume of inertia (solid, units X^5).
2) Printing:  Seems like should allow  TC options for a roll, with a specified length; also, if multiple items on a sheet, should be able to isolate by print view, and not loose the full size scaling.
Thanks for the considerations.  Roger

Logged


March 23, 2011, 08:27:21 AM
#1
I think you have posted this in the wrong sub forum. This section is for the TurboCAD CAM plug-in. It looks as though this has already been discussed in the "General Discussion" thread. http://forums.turbocad.com/index.php/topic,5577.msg31770.html#msg31770

Logged
TurboCAD user since v3
 TurboCAD on flickr || My twitter ||