TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When posting a problem be sure to include which version you are using.  Give as much information as possible.  If the problem is with a specific file be sure to attache it to your post.

10 Area of Inertia to Moment of Inertia, & 2) Printing from rolls.
Read 2692 times
* March 23, 2011, 07:18:47 AM
1)  For a solid, I believe TC shows a volume of inertia (e.g. vol *X^2) which units would be X^5, not the X^4 shown.  I think it should be modified to show wether it is an area of inertia (for a membrane, units X^4), or a volume of inertia (solid, units X^5).
2) Printing:  Seems like should allow  TC options for a roll, with a specified length; also, if multiple items on a sheet, should be able to isolate by print view, and not loose the full size scaling.
Thanks for the considerations.  Roger

Logged


March 23, 2011, 08:27:21 AM
#1
I think you have posted this in the wrong sub forum. This section is for the TurboCAD CAM plug-in. It looks as though this has already been discussed in the "General Discussion" thread. http://forums.turbocad.com/index.php/topic,5577.msg31770.html#msg31770

Logged
TurboCAD user since v3
 TurboCAD on flickr || My twitter ||