TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
The purpose of these forums is to discuss TurboCAD.  Please keep the discussion of other products to compatibility issues or how the other software’s can be used with TurboCAD.


How to EXACTLY position a counter bore hole in Turbo Deluxe Mac
Read 1365 times
* January 30, 2011, 03:58:10 PM
Can some me please tell me how to make sure I position the counterbore holes exactly where I want it to go.  As now, I have to move the location by mouse and I can never get the CB to the exact spot of interest ( because my hand is not stable enough).

Thanks

Logged


* January 30, 2011, 04:06:16 PM
#1
May I suggest invoke cross hair at the location your desire as reference point.Then if this not useful. Try the link below.

http://tcmacforum.imsisupport.com/

Logged
Even a mistake may turn out to be the one thing necessary to a worthwhile achievement Henry Ford
If I have ever made any valuable discoveries it has been owing more to patient attention than to any other talent Isaac Newton
I have not failed Ive just found 10,000 ways that won't work Thomas Edison


* February 01, 2011, 12:59:31 PM
#2
Hi wd,

Thanks.  This suggestion improved my postitioning but I am still off by 0.1 inch.

Thanks for the help.
I will also try mac forum. :)
Byron

Logged