TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
The purpose of these forums is to discuss TurboCAD.  Please keep the discussion of other products to compatibility issues or how the other software’s can be used with TurboCAD.


12.5 Rail Sweep
Read 1133 times
* October 07, 2010, 01:28:29 PM
This is a hand wheel. I have rotated the profile into several positions and it still sweeps the same way and of course it is wrong. It sweeps the profile 90 DEG from
where it is showing. I have tried rotating the part at 90 180 and 270 and get the same results.

Logged


October 07, 2010, 02:14:57 PM
#1
Have your tried just a sweep, not rail sweep?

Logged
"Be who you are and say what you feel.. because those who mind do not matter, and those who matter do not mind"


* October 07, 2010, 05:08:07 PM
#2
Oops. Ya that was it. It was late. Thanks.

Logged