TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
All posts discussing pricing or where to buy TurboCAD will be deleted.

Workplane Position, X vector, Up vector
Read 1137 times
* July 12, 2010, 07:51:57 AM
Would anyone like to give me a brief explanation of these three parameters in the Design Director.  The on-line help is not too clear (at least to me).

Thanx

Ed

Logged
Rel 20 Pro Platinum


* July 12, 2010, 12:45:59 PM
#1
Would anyone like to give me a brief explanation of these three parameters in the Design Director.  The on-line help is not too clear (at least to me).

Thanx

Ed

They provide a means to adjust the location and orientation of the selected Workplane with respect to the World Workplane. I find this method of WP adjustment rather awkward; IMO it's much easier to enter values in the Inspector Bar fields after activating "Edit Current Workplane." (Be aware the WP must be made visible before it can be edited.)

Henry H

Logged


* July 12, 2010, 02:37:23 PM
#2
Henry-

Thank you very much.

Ed

Logged
Rel 20 Pro Platinum