TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
The purpose of these forums is to discuss TurboCAD.  Please keep the discussion of other products to compatibility issues or how the other software’s can be used with TurboCAD.


Wall problem
Read 1076 times
* June 17, 2010, 06:02:39 PM
I have run across a wall configuration that I have been unable to figure out a  solution for. Maybe someone here can give me a clue. I have attached a file showing what happens when I use the wall tool, and one I have done with lines that looks like what I want. Is there a solution for this problem.
  Myron TC16.2Pro

Logged


* June 17, 2010, 09:36:36 PM
#1
No doubt there are more elegant solutions, but here's one that seems to work.

Henry H

Logged


* June 18, 2010, 07:45:27 AM
#2
Thanks Henry, with a little trial and error I can get it to work. It takes a little practice. I was using the line length tool and it was not working. With the edit tool if I move It  in small increments I  got it to work.
  Myron TC16.2 Pro

Logged