TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When posting a problem be sure to include which version you are using.  Give as much information as possible.  If the problem is with a specific file be sure to attache it to your post.

more on subscript out of range error
Read 2051 times
March 26, 2010, 06:21:51 AM
I have done a total reinstall of Mech 16.   simply load the attached file  insert a 3d bolt from sdk samples (its the top selection on the list)  give it a diameter of .19 a length of 2" and 1.5" of thread.  hit ok and presto! the error message subscript out of range.  Go back to sdk samples and everything is greyed out until the program is closed and restarted.

Logged


* March 26, 2010, 05:10:48 PM
#1
Thanks for providing the values. Although I'm not getting the "everything grayed out" effect that you describe (or perhaps I'm just not recognizing it), I am getting "subscript out of range" errors when I go below a diameter of about 0.27. I'll try to find out why that's happening.

Logged


March 29, 2010, 06:40:31 AM
#2
Thanks for the help. I was going nuts trying to make bolts.

Tom

Logged