TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When posting a problem be sure to include which version you are using.  Give as much information as possible.  If the problem is with a specific file be sure to attache it to your post.

subscript out of range error using Ver16.2 mech (revised)
Read 2271 times
March 04, 2010, 11:49:08 AM
  I have used the SDK Sample 3d bolt provided with Ver. 16.2 mech. as an add on, with success however when I try to make it into a 4-40 slotted bolt. I get the error message "subscript out of range", and then a crash when I try to select the bit of the bolt that remains after the error message.  Is it me? or is it a bug?

Thanks
GM
« Last Edit: March 18, 2010, 06:44:20 AM by Gammaman »

Logged


* March 18, 2010, 10:57:50 AM
#1
Hi Gammaman,

When you installed TC, did you do a full install or a custom install? If you didn't do a full install, maybe some of the pieces the Bolt tool requires didn't get installed. You might try changing the installation (Control Panel/Add or Remove Programs) to be sure all the features are present, or a repair on the installation.

If that doesn't solve it, tell me what exact steps you are taking, and any values you are entering so I can try to reproduce the problem.

Logged