TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

Trimming an inductor to half size
Read 188 times
* December 23, 2018, 02:43:27 PM
I haven't use TC version 16 in over 6 years and can't figure out how to cut a four turn inductor in half even after reading the help manual...The reason I want to do this is to make a link coupling inductor that will give me the two turn link I can use with the four turn inductor to complete the schematic symbol. Any help is greatly appreciated.....thanks John

Logged


* December 23, 2018, 02:55:14 PM
#1
The actual version is 16.2   2 Dimension...John

Logged