TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Remember to do a search before you ask a question!!!

2D Trim Problems
Read 392 times
* January 22, 2019, 05:48:18 AM
Gents,

Just wanted do a fast sketch in 2D en extrude and 3D print.
But as usual my skills is tested hard.

First I set out an rectangle, fillet and offset.
I set out a vertical line and offset this one bot side for use to trim.

I want to trim whats between the two lines with different lengths -  BUT I am not able.

Anyone who can tell me why ?

Best regards
NeverStop

Logged


* January 22, 2019, 06:02:27 AM
#1
Because you have Added constraint to to the Objects it's not possible to Trim.
I deleted the blockmarks ( Constraints ) and the Trim work like a charm, but is this  what you want to do ??

Torfinn

Logged
V18, V19, V20, V21, 2015/ 16/ 17/ 18 Pro. Platinum
Deluxe V20, V21, 2015/ 16/ 17
RedSDK enabled
Windows 10 Home Premium 64 bit, 32 GB
NVIDIA Geforce GTX 780m, 1 GB


* January 22, 2019, 06:06:19 AM
#2
Thanks Torfinn,

How did I add constrains ?
And how did you delete block marks / constrains ?

Best regards
NeverStop


Logged


* January 22, 2019, 06:15:19 AM
#3
Maybe by bad Luck :)

Down in left corner of your screen there is a mark for Auto add Constraint, maybe by accident you click on it when you want to click on the x for Cancel/ Escape or similar.
The Constraint layer was turned of, turned it on and then ctrl + t and selected Block Marks, delete and trim work like a charm

Torfinn

Logged
V18, V19, V20, V21, 2015/ 16/ 17/ 18 Pro. Platinum
Deluxe V20, V21, 2015/ 16/ 17
RedSDK enabled
Windows 10 Home Premium 64 bit, 32 GB
NVIDIA Geforce GTX 780m, 1 GB


* January 22, 2019, 06:23:12 AM
#4
YESS - Worked...

Typical fingers bugs :-)

Thanks Torfinn...

Logged