TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
The purpose of these forums is to discuss TurboCAD.  Please keep the discussion of other products to compatibility issues or how the other software’s can be used with TurboCAD.


Slow pan screen
Read 309 times
* November 13, 2018, 06:22:37 AM
My supplier send me a AC2007 dwg, when I load it in TC2018, the panning not very smooth. I tried other AC clone like AREX and BricX but they pan smoothly just like AC2007. How to speed up the screen drawing?

Logged
TurboCAD Pro Platinum 2018 64-bit


* November 13, 2018, 06:29:27 AM
#1
Are you in wireframe mode ??
And is the drawing very big ( Mb )
If possible attach/ upload the dwg file

Torfinn

Logged
V18, V19, V20, V21, 2015/ 16/ 17/ 18 Pro. Platinum
Deluxe V20, V21, 2015/ 16/ 17
RedSDK enabled
Windows 10 Home Premium 64 bit, 32 GB
NVIDIA Geforce GTX 780m, 1 GB


* November 13, 2018, 10:12:20 AM
#2
Assuming this is TurboCAD 2018, try "Options / Native Draw" and checkmark "Flicker free draw". This usually smooths out Dynamic Pan / Examine.

Logged
John R.

V17—V21, 2015—2018
Designer, Deluxe, Expert, Basic, Platinum
RedSDK enabled
Windows 10, 64-bit


* November 13, 2018, 07:01:47 PM
#3
The drawing is send by my vendor, it cannot be share. The file is not very big, only 314K, other AC clone can pan very smoothly.

I checked the "Flicker free draw", it makes the screen pan even slower.

Logged
TurboCAD Pro Platinum 2018 64-bit


* November 14, 2018, 03:22:19 AM
#4
If there is a lot of spline's in like a brush/ hatch it can slow down TC aswell, then it is to get rid of them if possible

Torfinn

Logged
V18, V19, V20, V21, 2015/ 16/ 17/ 18 Pro. Platinum
Deluxe V20, V21, 2015/ 16/ 17
RedSDK enabled
Windows 10 Home Premium 64 bit, 32 GB
NVIDIA Geforce GTX 780m, 1 GB