TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When replying to a specific statement be sure to quote the previous post.

New Learner
Read 556 times
* October 21, 2018, 04:35:47 PM
Hi all, Have just installed Turbo Deluxe 2018. I'm now retired but I did use Turbocad V6.5 on Win NT for drawing Pipeline schematics.
 So bear with me If I ask some dumb questions. The first one is "How do I stop Turbocad Pro & other builds from popping up on startup ?. I have been ticking the box "Do not show again" but it always comes back. I have also unticked the TC start in setup.
 The program also takes a long time to start.

Any suggestions
KparXNTHVG

Logged


* October 21, 2018, 05:04:41 PM
#1
Welcome.   

Does This thread help.  it sounds like a similar problem.


Logged


* October 21, 2018, 07:07:27 PM
#2
Thanks Andy, I followed the instructions & now OK
Kpar

Logged