TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When replying to a specific statement be sure to quote the previous post.

fretsaw
Read 91 times
* October 06, 2018, 04:51:03 PM
A few nights ago I fancied drawing something.  So I decided on an old fretsaw machine I still have, which I think is from the 1970's.

Instead of the more usual motor driven saw, this uses an electromagnet.  The spring steel at the top of the arm keeps the blade under tension.  The electromagnet pulls down the 'vibration plate' (I call it that because I don't know the correct name), then releases.  It continues the cycle until switched off.

« Last Edit: October 06, 2018, 05:32:42 PM by Andy H »

Logged


* October 06, 2018, 06:14:19 PM
#1
Great job on a complex project, Andy.

Henry H

Logged


October 06, 2018, 07:49:16 PM
#2


* October 06, 2018, 09:20:12 PM
#3
Very nice model.

All I have is an old Eclipse FS70 fret saw and a no name coping saw.

Logged
John R.

V17—V21, 2015—2018
Designer, Deluxe, Expert, Basic, Platinum
RedSDK enabled, except in 2018
Windows 10, 64-bit