TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Interested in some really terrific mobile apps? Visit www.turboapps.com for details.

Cannot see my cursor?
Read 299 times
* August 04, 2018, 02:32:12 PM
After getting a previous issue somewhat resolved.  Now I can not see my cursor.  Or, snap aperture, or preview when drawing a line?  any ideas?

Logged
TuboCad Deluxe 2017. 
Newbie, but Getting There.


* August 04, 2018, 08:23:31 PM
#1

Logged
-----------------------------------------------------------------------------------
Very low knowledge of English - I ask for indulgence - Thanks
Currently installed
TurboCAD  Professional 32-bit V.17.2.77.1
TurboCAD 2016 ProPlatinum 64-bit V23.2-61.2 engl.
TurboCAD 2015 2D V.22.2.51.4
on Win 10.


* August 11, 2018, 07:30:16 AM
#2
Well, I sort of fixed it.  by looking at the links you provided.  I can see my cursor in wireframe now.  Still not in in any kind of render mode.  Also, render mode is not a very good quality.    It asks to turn on RedSDK when I start a drawing. My Graphics card is supported, it says.  But, if I do, the software is un-useable.  Any other ideas?  I was thinking of upgrading to 2018, but, I am having second thoughts.  Not going to upgrade to the same issues.   I have used 2017 for some time, with no issues, now this.  And, I cant figure out why.  Any ideas, suggestions would be greatly appreciated.

Logged
TuboCad Deluxe 2017. 
Newbie, but Getting There.


* August 12, 2018, 10:09:23 AM
#3
Well, I am going to give a TC2018 a trial run before purchasing.  Hopefully, it will work better than what I have?  Not blaming the software, I am just a novice user, and having a hard time with all the perameters, I think. 

Logged
TuboCad Deluxe 2017. 
Newbie, but Getting There.