I am wondering if anyone is running Turbocad on an HP 400-334 Pavilion Slimline Desktop PC with 16 gig of RAM and if so, is it performing half way decent?
It has the AMD two core E1 2500 chip runs at 1.4 gig.
Right now I have that box but with only 4 gig or RAM and I was wondering if I maxed out the ram to the 16 gig is it worth spending the 150 bucks for the new ram?
TC Platinum 2017 runs very slow on it, especially when I switch over to page view to see drawings in 3D.
I have been shopping for a new PC but thinking I might want to wait until Intel comes out with that hardware fix for Spectre and Meltdown problems - from what I have been reading they expect to come out with a new line of chips that will have a hardware fix second half of this year.
I was looking at an Asus board, just got off the phone with Asus - their support dept said they are not even releasing BIOS upgrades any more, until Intel comes out with microcode patches for all three variants and MS comes out with their patches. Asus was releasing BIOS fixes but it caused crashes with the too early released Intel patches. I was not aware this was this big of a problem until this week when I started shopping for a new PC and started reading about the problem.