TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

When posting a problem be sure to include which version you are using.  Give as much information as possible.  If the problem is with a specific file be sure to attache it to your post.

New drawing Solid state relay
Read 1171 times
April 13, 2018, 10:55:25 AM
Hi I made this because I couldn't find a good photo or picture anywhere.
I did take me a whole but I was very pleased with the outcome
I learned a lot doing this, especially on the Resistors :)

Deluxe 2017

Using Plat Pro 2018
Windows 10 - 64-bit
Nvidia K620
But still slow :(

April 14, 2018, 01:58:29 AM

    it looks really good to me.
    It makes a nice change to see something electrical.  8)

Regards Tim

You can design without engineering, but you cannot engineer without design.
Using Win 10 with Designer 2017 and TurboCAD Pro. Plat. 2016/2017/2018 + Lightworks (64-bit versions) + AnimationLab.

* April 15, 2018, 05:13:29 PM
Nice work James, looks lie you even did the soldering joints,  maybe just a tiny bit too much reflection on the resistors, I like the track colour, looks realistic.


April 16, 2018, 03:57:00 PM
Hi Chaps, thank you for the comments :)
Yes I made soldering joints cos it looked really plain without them and I used the revolve tool for them :)
And yes the resistors do look a little shiny but by the time I got them to look this way I had had enough and just wanted it finished :) hahahahaha

Using Plat Pro 2018
Windows 10 - 64-bit
Nvidia K620
But still slow :(

April 19, 2018, 06:33:26 PM
As an electronic engineer, I can say that them are some funny-lookin' resistors, but the solder job looks fully IPC-A-610 compliant.  ;)


TC Pro Platinum 2019, 2018, 2017, 2016 & 2015 (all with LightWorks & RedSDK) & V21
System: i7-5820K @ 3.30GHz, ASRock X99 Extreme4, 16GB DDR4-2133 RAM, Gigabyte GTX 970, Samsung NVMe SSD 950 (256GB), Windows 7 Pro (64-bit) SP1

* April 25, 2018, 08:02:51 AM
Well, to me just starting out, this is really amazing.