TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Interested in some really terrific mobile apps? Visit www.turboapps.com for details.

Bevel
Read 226 times
* April 12, 2018, 01:05:28 AM
Is it possible to reverse the round bevel.in a solid. I seem to remember in one of Dons Tut he reversed the round bevel .I cannot find it in the manual. I am using 21 with windows ten  NJR

Logged


* April 12, 2018, 08:57:55 AM
#1
Like this ...?

Henry H

Logged


* April 12, 2018, 09:23:42 AM
#2
I believe Don used the Quick Pull tool with the "Detect Blend Network" active. Click on the blended portion, then pull it out or enter zero in the Inspector Bar.

Logged
John R.

V17—V21, 2015—2018
Designer, Deluxe, Expert, Basic, Platinum
RedSDK enabled
Windows 10, 64-bit


* April 12, 2018, 02:25:50 PM
#3
Is it possible to reverse the round bevel.in a solid. I seem to remember in one of Dons Tut he reversed the round bevel .I cannot find it in the manual. I am using 21 with windows ten  NJR

Neville, I should have asked this earlier: What do you mean by "reverse" the bevel?

Henry H

Logged


* April 12, 2018, 05:31:58 PM
#4
Henry You have covered it in Fillet the reentrant edge. But i am sorry i do not know how to do this.Thanking you neville

Logged


* April 12, 2018, 05:45:43 PM
#5
Henry You have covered it in Fillet the reentrant edge. But i am sorry i do not know how to do this.Thanking you neville

Neville, just activate the Fillet Edges tool and click on the reentrant edge, then click the "Finish" icon on the Inspector Bar. See attached screenshot.

Henry H
« Last Edit: April 12, 2018, 05:49:41 PM by Henry Hubich »

Logged


* April 13, 2018, 12:44:47 AM
#6
Henry I have been expecting too much. I thought I could just reverse the bevel and it would curve in instead of out. But now I know what I have to do thank you once again
Neville. I found what Don did but it was for a bevel with two different sizes you use ctrl when doing it.

Logged


* April 13, 2018, 07:39:05 AM
#7
Henry I have been expecting too much. I thought I could just reverse the bevel and it would curve in instead of out. But now I know what I have to do thank you once again
Neville. I found what Don did but it was for a bevel with two different sizes you use ctrl when doing it.

I don't know how to do that easily, but that doesn't mean it can't be done.

Henry H
« Last Edit: April 13, 2018, 07:43:03 AM by Henry Hubich »

Logged