TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
Be sure your post is relevant to the current discussion.  Create a new topic within the appropriate board if you are unsure.

Dynamo 2018
Read 320 times
April 10, 2018, 05:28:52 PM
Here is a dynamo based on the recent machining series made by mrpete222 on youtube. I hope you like it.


April 12, 2018, 05:30:09 AM
#1
Hi Don,

    yes, I like it a lot! Particularly, detailing of the castings and windings.

    However, it looks like the armature slip-ring is the same OD as the shaft. Is this what you intended?

Regards Tim

Logged
You can design without engineering, but you cannot engineer without design.
Using Win 10 with Designer 2017 and TurboCAD Pro. Plat. 2016/2017 + Lightworks (64-bit versions).


April 12, 2018, 07:28:55 AM
#2
Hi Don,

    yes, I like it a lot! Particularly, detailing of the castings and windings.

    However, it looks like the armature slip-ring is the same OD as the shaft. Is this what you intended?

Regards Tim

Hi Tim, I think you are just pointing to a reflection, not a slip ring, as there was no slip ring in the build.


* April 15, 2018, 05:00:48 PM
#3
Looks good Don.   

Logged


April 19, 2018, 06:27:08 PM
#4
Very nicely done.

Did you intend for the metal frame at the end to appear aluminum?


Jeff

Logged
TC Pro Platinum 2018, 2017, 2016 & 2015 (all with LightWorks & RedSDK) & V21
System: i7-5820K @ 3.30GHz, ASRock X99 Extreme4, 16GB DDR4-2133 RAM, Gigabyte GTX 970, Samsung NVMe SSD 950 (256GB), Windows 7 Pro (64-bit) SP1


* April 26, 2018, 08:24:52 AM
#5
Don, I assume that you had 2D plans of the Dynamo to go by?

Donnie

Logged


April 26, 2018, 09:30:38 AM
#6
Don, I assume that you had 2D plans of the Dynamo to go by?

Donnie


Just took the dimensions from the drawings mrpete showed while talking about it on his video.