TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
The purpose of these forums is to discuss TurboCAD.  Please keep the discussion of other products to compatibility issues or how the other software’s can be used with TurboCAD.


"Copy in Place" and "Spline by fit points"
Read 414 times
* April 10, 2018, 10:02:27 AM
Is there is reason why the "copy in place" is grayed out for the "spline by fit points" ?   After I make a complex curve, I would like to use the "copy in place", but it is grayed out. The other options that does work is the "Rubber Stamp"

Thanks for anyone willing to help.  (or is this just the nature of the program)

Donnie

Logged


* April 10, 2018, 10:13:37 AM
#1
Do you have the Spline ‘selected’? You can't copy until something is selected. What version/edition are you using?
« Last Edit: April 10, 2018, 10:15:58 AM by John R »

Logged
John R.

V17—V21, 2015—2018
Designer, Deluxe, Expert, Basic, Platinum
RedSDK enabled
Windows 10, 64-bit


* April 10, 2018, 02:16:33 PM
#2
Hi John,
I found the problem. I was in hidden line mode instead of wireframe mode.... Good Grief...
« Last Edit: April 10, 2018, 02:18:43 PM by DDriskell »

Logged