Basic Training Session 3

The Ultimate Resource for TurboCAD Knowledge

When posting a problem be sure to include which version you are using. Give as much information as possible. If the problem is with a specific file be sure to attache it to your post.

Go Down

Basic Training Session 3
Read 558 times

Next Previous

February 24, 2018, 04:59:13 AM

Hello everyone, I am new to TC Deluxe 2017 and I'm in Session 3 where I moved the workplane to the top surface. Then select large circle and move to workplane. But when I do this, the wokplane goes back to the bottom and circle doesn't move.
I can't get by this. Please help.
Thanks - Bob

Logged

TC19, TC24, Lightworks, TC2018Deluxe, TC2018 PP + Animation Lab

February 24, 2018, 05:22:16 AM

Maybe you are in 2D mode, is there a 2 or 3 selector arrows when you select the circle ??

Torfinn

Logged

V18, V19, V20, V21, 2015/ 16/ 17/ 18 Pro. Platinum
Deluxe V20, V21, 2015/ 16/ 17
RedSDK enabled
Windows 10 Home Premium 64 bit, 32 GB
NVIDIA Geforce GTX 780m, 1 GB

February 24, 2018, 07:18:13 AM

Quote from: Torfinn on February 24, 2018, 05:22:16 AM

Maybe you are in 2D mode, is there a 2 or 3 selector arrows when you select the circle ??

Torfinn

Thank you Torfinn, I was in 2d mode. Switching to 3d mode did it.

Logged

TC19, TC24, Lightworks, TC2018Deluxe, TC2018 PP + Animation Lab

Go Up