TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When posting a problem be sure to include which version you are using.  Give as much information as possible.  If the problem is with a specific file be sure to attache it to your post.

Post processor for Wabeco Mill, controller by MAXcomputer GmbH
Read 470 times
* February 22, 2018, 01:32:15 PM
Does any kind sole know of a post processor for a Wabeco Mill. The G Code commands are said to comply with DIN/ISO 66025. The controller is a Kosy manufactured by MAXcomputer GmbH.

Logged