TurboCAD Forums

The Ultimate Resource for TurboCAD Knowledge

Register
 
When posting a problem be sure to include which version you are using.  Give as much information as possible.  If the problem is with a specific file be sure to attache it to your post.

Tolerance symbols not showing exactly same in imported dwg file into TC.
Read 783 times
September 29, 2017, 05:28:57 AM
Reason:
If the drawing's extents exceeds 1000 000, it is need to switch on "Double precision". See also REDSDK_doubleprecision.doc REDSDK_doubleprecision.doc

Please see the image attached.

« Last Edit: September 29, 2017, 12:22:49 PM by Zunair Attif IMSI »

Logged
Thanks & Regards,
Zunair Attif
Manager QA\Support
IMSI Design
Email: [email protected]
Skype: [email protected]


* September 29, 2017, 11:32:50 AM
#1
It would help if images were readable when clicked on. "Old" Help file images are the worst.
« Last Edit: September 29, 2017, 11:35:11 AM by John R »

Logged
John R.

V17—V21, 2015—2018
Designer, Deluxe, Expert, Basic, Platinum
RedSDK enabled, except in 2018
Windows 10, 64-bit